Ward Burner Systems

Customized Combustion Equipment

 
Burner Components

Target Type Pilot

This pilot burner can be used on all types of burner systems where wind and port blowback is not a factor. It energizes the thermocouple and ignites the main flame front. A threaded coupler holds the thermocouple in perfect position. This burner is made from steel. Some pilots of this style are made, in part, of aluminum which can melt from the high ambient port temperatures of stoneware kilns. NOTE: May be unstable at pressures greater than 2 PSI.

Price: $68.95



Rectifying Pilot

This pilot burner can be used on burner systems where wind and port blowback is not a factor and that use an intermittent pilot control (see below). This burner is made from steel. Some pilots of this style are made, in part, of aluminum which can melt from the high ambient port temperatures of stoneware kilns. NOTE: May be unstable at pressures greater than 2 PSI.

Price: $74.50









Blower Speed Control

This solid state speed control is designed for use with PSC (permanent split capacitor) or shaded pole blowers like the ones we use on our MB POWER BURNERS. Ordinary dimmer switches can damage the motors mentioned above.


Price: $53.95


Flame Retention Nozzles

These type nozzles are open flame heads designed for high capacities with good flame retention characteristics.  High capacities are made possible by large burner area in relation to flame tube size. These nozzles are designed to handle rich gas-air mixtures while using relatively low mixture pressures. Other sizes than those listed are available.  Please call for additional sizes and price.  Sizes apply to the thread size of pipe that the nozzle is screwed onto (the "T" measurement). See the bottom of our Technical Dowload page for a printable form that measures male and female pipe sizes.


"T" Pipe
Size

"D"
diam

"L"
length

"O"
opening

Price

2"
3"
2 1/2"
1 1/2"
$139.00
2 1/2"
3 5/8"
2 7/8"
1 5/8"
$209.00





Spark Ignition Module

The CAM-STAT P120 is used to protect a standing pilot from being extinguished. The unit works by emitting very intense, pulsed electrical arcs. The electrode senses a flame outage in less than 1 second and begins pulsing at 300 cycles per minute until the flame is re-established. It's automatic and instant lighting makes this unit a very safe and trouble-free addition. Must be wired to a properly grounded 120Vac line. (cannot use GFI circuitry)

Price: $ 109.50

Heavy Duty Electrode & Wire

For those requiring a heavier and longer (6") electrode, this unit can be used with the Cam-stat P120 above. A more durable electrode than supplied with the Cam-Stat. Heavy silicon, high-temp wire with spark plug cage is the wiring method.

Electrode: $19.95        Wire w/cage & boot: $4.50 per foot




Intermittent Pilot Control

This safety control is designed for indirect burner ignition and supervision. Used with a rectifying pilot, it provides spark ignition and flame monitoring with shutdown times under 1 second. Can be used with all fuel gases. This is a 24volt system designed to be used with 24volt solenoids.

Price: $159.00