logo image
  • Home
  • Burners
    • Power Burners
    • Venturi Burners
    • Rectified Burners
    • Distillery & Brewery Burners
    • Kettle & Pot Burners
    • Pilot Burners
    • Raku Burners
  • Burner Components
    • Burner Parts
    • Manual Gas Valves
    • Safety Valves
    • Thermocouples
    • Hose and Flex Connectors
    • LP Tank Gang Connectors
    • Regulators & Blowers
    • Fitting & Clamps
    • Burner Stands
  • Other Products
    • Pyrometers
    • Pressure Gauges
    • Orifice Charts & Plugs
    • TempGuard Vent Pipe
  • Technical Info
    • Data Guide
    • Technical Articles
    • Technical Downloads
    • Basic Glossary
    • Basic Troubleshooting
    • Burner Placement
    • Forced Air vs Venturi Burners 2
    • Projects
  • Ordering Info
    • Burner Ordering Info
    • General Ordering Info
    • Mail/Fax Order Form
  • Contact us
865.397-2914
image

Pilot Burners

image
Ransome P8SSC (Piggyback) Pilots
These pilots are also known as Piggyback Pilots and are Venturi style pilots that provide a stable pilot flame in windy and excessive back-pressure environments. Thermocouples enter through the back of the burner head and the thermocouple tip is surrounded by pilot flames emerging through the pilot's welded baffle plate. Because of their high relative output, they can also be used as preheat burners. These pilots can also be equipped with spark electrodes and flame rods. Unlike simple target type pilots, these pilots can handle a wide range of gas pressures. Price: $159.00
Honeywell Q314A 4586 Target Type Pilot

This pilot burner can be used on all types of burner systems where wind and port blowback is not a factor. It energizes the thermocouple and ignites the main flame front. A threaded coupler holds the thermocouple in perfect position. This burner is made from steel. Some pilots of this style are made, in part, of aluminum which can melt from the high ambient port temperatures of stoneware kilns. NOTE: May be unstable at pressures greater than 2 PSI.
Price: $78.95
image
image
Honeywell Q345A 1305 Rectifying Pilot
This pilot burner can be used on burner systems where wind and port blowback is not a factor and that use an intermittent pilot control (see below). This burner is made from steel. Some pilots of this style are made, in part, of aluminum which can melt from the high ambient port temperatures of stoneware kilns. NOTE: May be unstable at pressures greater than 2 PSI.
Price: $84.50
Baso Q90AA-8C Rectifying Pilot with Spark

This pilot burner can be used on burner systems where wind and port blowback is not a factor and that use an intermittent pilot control. The Q90AA-8C is custom made by Baso for Ward Burner Systems and features a longer (5ft.) ignition wire.Pilot comes with separate Natural Gas and Propane orifices. (Please specify when ordering). Designed for low pressure only. Flame sensor is replaceable. (see below)
Price: $99.95
image
image
Baso Y75AA-8 Replacement Electrode

Replacement electrode for the Baso Q90 series Rectifying Pilots.
Price: $23.50
image
image
Copyright © All rights reserved.
About Us
Serving the Combustion Industry for over 40 years
Address
1925 Alamo Trail • PO Box 1086 • Dandridge TN 37725 US
Contact
(865) 397-2914
info@wardburner.com